Pairing KeyFobs to Remote Immobilizer

The process of pairing keyfobs to remote immobilizer is the following:

Button A - ON Button B - OFF

• Push marked button on the RF board 3 times;
• LED light shall turn ON;
• Push A on the Keyfob;
• Push A on the Keyfob again (LED light on the RF board shall start to blink);
• Push B on the Keyfob (LED light on the RF board shall turn OFF).

Button B - ON Button A - OFF

• Push marked button on the RF board 3 times;
• LED light shall turn ON;
• Push B on the Keyfob
• Push B on the Keyfob again (LED light on the RF board shall start to blink);
• Push A on the Keyfob (LED light on the RF board shall turn OFF).

Button A - ON then 2nd push - OFF

• Push marked button on the RF board 3 times;
• LED light shall turn ON;
• Push A on the Keyfob;
• Push A on the Keyfob (LED light on the RF board shall start to blink);
• Push A on the Keyfob (LED light on the RF board shall turn OFF).

 If you purchased M4M Immobilizer with multiple removes you will get special transparent cover on RF board that helps you add / and re-program additional keyfobs.

You can purchase additional keyfobs here:

Additional Keyfobs