Central Console Electronics of Segway miniPRO

Tools Required: 2.5 mm hex wrench

#1 Phillips-head screwdriver

Removal

Make sure the miniPRO is powered off and the charger is not c
Remove the following components:

Battery

WARNING! Press the Power Button until all lights are off to discharge any power remaining in the miniPRO.

Steering Knee Controlled Bar
Steering Assembly
Decorative Front Strip
Decorative Rear Strip
Both Foot Pads
Center Console

Remove the silicone plug on the side of the Center
Using a 5 mm hex wrench, remove the fastener under the silicone plug

Using a #1 Phillips-head screwdriver, remove the four fasteners around the D-Sub connector

Gently pull the two halves of the Center Console

Att: You may need to lift the locking tab.

Unplug the speaker harness
Using a #1 Phillips-head screwdriver, remove the three fasteners shown in the picture below

Gently remove both the circuit board and the dashboard electronics together.
Pull apart the circuit board and the dashboard electronics to separate them

Using a #1 Phillips-head screwdriver, remove the two fasteners shown the picture below:

Pull the dashboard electronics board off the plastic housing

Att: There is a plastic shell on the power button. When installing, make sure the slot on the plastic shell lines up with the tab on the plastic housing.

Using a #1 Phillips-head screwdriver, remove the two fasteners shown in the picture below:

Remove the speaker.